What Vlan Does Dtp Use
VLAN trunks formed using DTP may utilize either IEEE 802.1Q or Cisco ISLCisco ISLCisco Inter-Switch Link (ISL) is a Cisco Systems proprietary protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. … This is a key advantage for IEEE 802.1Q as it means tagged frames can be sent over standard Ethernet links.https://en.wikipedia.org › wiki › Cisco_Inter-Switch_LinkCisco Inter-Switch Link – Wikipedia trunking protocols. DTP should not be confused with VTP, as they serve different purposes. VTP communicates VLAN existence information between switches. DTP aids with trunk port establishment
Related Searches
What Number Is The Default VLAN?
This VLAN is called the DEFAULT-VLAN and is VLAN number 1
What Is The Default Vlan
Typically, the default VLAN refers to the one that all of the ports on a device belong to when it is switched on. On most switches, this default is VLAN 1 and should be changed for security reasons
What Is Management VLAN?
Management VLAN is used for managing the switch from a remote location by using protocols such as telnet, SSH, SNMP, syslog etc. Normally the Management VLAN is VLAN 1, but you can use any VLAN as a management VLAN. ... You must configure IP address and default gateway for Management VLAN
How Do I Delete A VLAN Interface?
Use the dladm delete-vlan command to delete VLAN configurations on your system. Note - You must first delete any existing IP configurations on the VLAN that you intend to delete before you can delete the VLAN. Deleting a VLAN fails if IP interfaces exist over the VLAN
How Do I Remove A Default Vlan From A Cisco Switch
- From global configuration mode, enter interface Ethernet configuration mode. device(config)# interface ethernet 1/1/1. - Enter the remove-vlan all command to remove all VLANs from the Ethernet port. Enter the remove-vlan vlan command to remove the VLANs from the Ethernet port